|  Newsletter
Blogs  |  ProTV  |  Message Boards  |  Sweepstakes  |  Best of HGTVPro
HGTVPro.com
Newsletter Signup
Subscribe to HGTVProFile for
timely information on new
products, best practices,
professional advice and more.

Subscribe Now!
Sponsored Content





Message Boards

 
  boards.hgtvpro.com
  HGTVPro Message Boards
Hop To Forum Categories   Best Practices
Hop To Forums   Mechanical
  Low water pressure shallow well
Go
New
Find
Notify
Tools
Reply
  
  Login/Join 
Posted
We just purchased a house knowing that there wasn't any water. It is speculated that something hit the well and broke. We dug down and noticed the nipple came off of the line. While we were working on it, water keep coming in from the well. For some reason the water would flow out of it. There isn't a submersible pump. It is a shallow well. We first thought that the water was from the low water table since we are on the river.

After the hoses were attached we went to the basement and primed the pump. We got a small stream to flow thru a garden hose to get anything out of the line that we could. Then we attached to the house and turned on the faucets. There was water but not any pressure.

Any suggestions would be greatly appreciated. It is a 2in well. Should we put in a submersible pump, large well - 4 inch pipe, different jet pump, drill down to another water table or something that we haven't thought of. The house is 18 years old.

Thank you so much for your time.
Sheila
 
Posts: 1 | Registered: 09 August 2007Reply With QuoteEdit or Delete MessageReport This Post
Posted Hide Post
First off, Not sure where you live, but I thought pretty much most mortgage companies would not allow closing with out a water source into a home and testing of the water. You took a big gamble on fixing the well after you purchased. Wells can become quite expensive quite quickly.

I would strongly suggest that you dig the well deeper and install a new pump.
Water that is deliverd from shallow wells tend to run out when dry weather comes along quite quickly.

However first off I would test the water that is coming out of the existing well to determine if any issues are present with the current supply BEFORE you drink it and before you decide to do any changes to what you have already there.

When wells are not very deep and are near an additional water source such as the river you talk about. Often become contaminated quite quickly. As there is not enough ground filtration to clear the bad stuff out of the water before it gets to the well point.
 
Posts: 952 | Location: New Jersey | Registered: 31 January 2006Reply With QuoteEdit or Delete MessageReport This Post
Posted Hide Post
The actual water pressure problem is probably something with the pump or a bent pipe somewhere. But like HC said, you should probably go with a new well for your safety and more water(although some shallow wells will have plenty of water because of underground rivers). Call a local well company and ask them for a free estimate.
 
Posts: 171 | Location: New Hampshire | Registered: 28 November 2006Reply With QuoteEdit or Delete MessageReport This Post
Posted Hide Post
hi, as far as I know, low water pressure could be due to the fact that you may need a booster within your system (they have technical solutions for it) or you may have a problem with your area regarding the region, meaning you need to talk to your municipality and neighbors before you go putting any money into anything..ok, I just reread your post which renders my answer completely useless... would it be possible for your municipality to connect you to the main line?? is it worth the investment? good luck, -Fishfool @ The Reef Tank
 
Posts: 20 | Registered: 16 June 2008Reply With QuoteEdit or Delete MessageReport This Post
 Previous Topic | Next Topic powered by eve community  
 

    boards.hgtvpro.com    HGTVPro Message Boards  Hop To Forum Categories  Best Practices  Hop To Forums  Mechanical    Low water pressure shallow well