Rich, When ProAdmin asks these 'best practice' questions, they are supposed to be in response to the HGTVPro videos of that topic which you can view by clicking the appropriate link in the upper right corner of this page or in the bar at the top listed 'best practices':
I am very interested in OVE Stack Framing. I am working on a LEED for Homes Pilot project so we are trying to reduce the amount a material used.
The only problem that I am having is utilizing a single top plate with precut walls studs makes the ceiling height less than 8'. But then if you use a full 8' stud, you have 2 3/8" gap between the finish floor and the bottom of the drywall.
So what would your solution to the problem be? We want to minimize material waste but also make it easier for the contractor to install.
Thank you for your time and comments.
Posts: 5 | Location: Ohio | Registered: 08 March 2005
Originally posted by Josh: I am very interested in OVE Stack Framing. I am working on a LEED for Homes Pilot project so we are trying to reduce the amount a material used.
The only problem that I am having is utilizing a single top plate with precut walls studs makes the ceiling height less than 8'. But then if you use a full 8' stud, you have 2 3/8" gap between the finish floor and the bottom of the drywall.
So what would your solution to the problem be? We want to minimize material waste but also make it easier for the contractor to install.
Thank you for your time and comments.
Fill the bottom gap with scrap drywall from window and door cutouts, and cover the mess with base board.
If you are wanting to reduce construction waste, you might want to concider using a customized panel system like the Ultra-Frame system from Transconsteel, supplied by EnerLoc Building Systems. www.enerloc.com
Posts: 4 | Location: texas | Registered: 23 August 2006
